Homeowner Forum / Security Alarms / August 2007

I have a DSC MD12 modem and it seems I often fight with getting a
working connection to panels that I know are programmed properly...in
fact if I go back to DLS1 and a 1200 baud modem on exactly the same
panel and I connect without issue.  This is all fine and good except

Mr. Rojas,
Do you even unlock panels?  I thought that after sending you panels in good
faith and trust over half a year ago that you would have plenty of time.

My older brother (Mid 50's) was flown to a hospital downstate (Michigan)
 on Monday.  He was in a coma and unresponsive following an early
morning trip to the emergency room with a severe headache.
The doctors told my sister-in-law that there is a baseball sized area of

Set up an alarm company
get an authorised dealer setup and hire some former residential alarm
installers from company you are authorised dealer for to work for you .
Then also hire some former Cable TV installers and go out and start

I lost my d5200's programming Y cable, can anyone tell me the pinouts for
the cable so I can make a new one. I am more concerned with the block
connector for the 9000 series panels than the modular jack connector.
I appreciate any advice,

We know how you feel! Why do you want to buy the latest designer
products at wholesale prices? Is it so you can have the best quality
products at unbelievable wholesale prices and save yourself money, or
is it so you can sell them online and make healthy profits and

I have been looking for a PC software based intrusion detection system
with the following features.  So far, there is nothing I have found in
existence that will do this.  Does any one have any suggestions?
I have looked at x10 stuff, but it doesn't seem to quite do what I

Just wanted to run my idea pass the group.
On Aug 11, 2007 someone stole the copper on the Main Ac units for my
church.
This made the Aug 12th services unbearable because the temp was 101

If a person offers concealment services ..i:e: fake  ,doorknobs
,,,receptacles that open, walls that move.. etc.  Is that illegal?
I did specialty design and installation but it was for hidden TV's , bars,
and such .. but now I'm retired and am bugged to death

I don't drive a Ferrari or wear $5,000 suits but I'll never have to
argue with my wife about money again, that's for sure. And it's all
possible because I discovered people can:
Get paid to take online surveys and make from $5 to $75 each, or more

got to go look at some ip cameras tommmorrow.  how do you adjust a ip
cam that is out on the side of a bldg?  do i have to take a network
switch and a laptop out there to get a  picture to look at while I
adjust the camera focus and what ever else might need adjusting?

Does anyone know who manufactures Accudome security cameras?

looked at a 3 story trim out with finished basement.  Not prewired for
fire.  owner wants fire monitoring.  Could use relay with Kidde AC smokes?
http://www.kidde.com/utcfs/ws-384/Assets/1275H_440381en.pdf
http://www.kidde.com/utcfs/ws-384/Assets/Sheet_Relay%20Modules.pdf

I have the ELK Battery tester for testing Panel Batteries. It says
that it is a Conductance tester and measures in MHOs/Siemens. Now the
Fluke 87V has a Conductance tester built in to it. So would that not
be the same and I could just use a 87V for testing panel batteries?

PASADENA, Md. (AP) - Doctors often warn of the health risks of eating
junk food but it seems the treats can be a problem for burglars, too.
Corporal Mark Shawkey, a spokesman for the Anne Arundel County Police
Department, says four teenagers broke into a Maryland gas station early ...