Homeowner Forum / Security Alarms / April 2005

One of the largest system integrators in the state of Florida is looking
for service and install techs in most major cities in Florida.  Good pay
training and benefits.  Mostly larger CCTV and Access control systems.  
Plenty of good work for the right person.

One of the largest system integrators in the state of Florida is looking
for service and install techs in most major cities in Florida.  Good pay
training and benefits.  Mostly larger CCTV and Access control systems.  
Plenty of good work for the right person.

                        TIME LINE                        
                   alt.security.alarms                    
       Year of 2004, aggregated on a weekly basis.        
890 |      O                                              

I need some help from you pros. I'm staring at an assessment question that
says something like this: "when installing a motion sensor in an odd-shaped
room, scope the perimeter and eliminate obstructions."
I'm assuming there is a device that I would look through that gives me some ...

I'm upgrading my old FBII panel to an Ademco. Ademco want 2K EOL and my
contacts all have 2.2K resistors in here. Is the Ademco panel going to be
okay with that? Seems close enough to me tolerance-wise but I'd feel better
if somebody's done it and all is well. I suppose I could 200R ...

Who wanted that image of a 4120 EC ?? ...I'm pulling one out tomorrow.

I'm trying to program user codes in my GEM-P816 panel using the
GEM-RP3DGTL keypad.  The manual is kind of confusing:
After selecting programming feature 14 to enter user codes, the manual
says to Press the [Function} key onece to set the cursor th the User

YOU have a wireless alarm system who has that maintenance pro's
"imaginative" Radio Frequency Interference (RFI) detection circuit?
Wireless Alarm systems are still unreliable DURRING RFI but...
If that famous "undocumented" and "manufacturer unsupported" RFI

Boy, I have just finished spending several hours trying to figure out what
is wrong,
and am still stumped.
Would really be most appreciative for any thoughts on the following:

We have an antiquated amag 3500 which has stopped allowing us to log
into it.  The manufacturer no longer supports the software.  Since we
are moving in a few months, I really don't want to spend money on this
replacing this system.

Does anyone have DSC PCLink (RS232 DB9) cable pinout?
I have googled around for a while but no luck :(
Thanks.

I have an Ademco LYNX-R system at home and just purchased an Ademco
7845CV2. I would like to disconnect my home phone line and just used
Alarmnet-C. Can anyone recommend a monitoring facility that is
reasonably priced? I'm in the Seattle Area.

I have been trying to program my Aux 1 output to follow the panel's
Armed state. I using the DL900 software I have Aux 1 set to type 21 and
the timer set to 0. According to the docs this should cause the Aux 1
output to follow the Armed state fo the panel. Of course this doesn't ...

would anyone here be so kind as to point me in the correct direction for
hooking up multiple GRI 2800 water sensors to a single zone on an HAI Omni
Pro II?

What do ADT motion detectors look like and where are they usually
installed? I live in a 3-family house, and the first floor tenants have
an ADT alarm system. Whenever I leave or enter the hallway, there is a
beep or chirp sound coming from inside of their apartment. I suspect