Homeowner Forum / Security Alarms / February 2005

Got a  kaba bedanet 9340 electronic clocking system. Can't telnet into
it because it's password protected. Know you can access it via a serial
cable. Anyone have a wiring diagram because Kaba want to charge a
fortune for one?

Can a Gem-1632 be defaulted back to original settings without the
existing dealer code?

I have a Power 832 and a Power 632 alarm panel.  How can I tell the version
# of each panel?
Thanks,

I posted the last message about internet phones and losing customers.
Thanks for all those responses.  I learned a ton about trhis subject.
I found that my customer uses Lingo voip service.
Apparantly Lingo just sends you a voip module in the mail.

Does anyone have any idea where I can get installation and user manuals for
this panel?
Thanks,

I am looking for an inexpensive receiver for alarm signals sent over
the phone.  This system is being used in a non burglar monitoring
situation.  We are using DSC 864 panels to send the signals.  I know
DSC and maybe others make a card for a PC, but it runs about $1,500.00,

Any comments on this?  I have lost 3 customers to voip internet phone
in past 3 months.
Usually I get a call saying their alarm panel went off but no one
called them.  I explain to them that security monitoring uses the

How can you reset a DSC (Power 832) panel to its default settings when you
don't know the installer password?
Thanks,

Is the Partner P-832 panel the same as the DSC Power 832 panel, or are there
differences?
Thanks,

Sonitrol of Albuquerque (EOE) The Industry Leader of Commercial,  
Industrial and Institutional Security Services is seeking an Integrated  
Security Installer.  Experience in Electronic Alarm Security, Access  
Control, Fire (Life Safety) and CCTV preferred.  Sonitrol of ...

I cannot get my Power832 communicator to dial my cell phone. After a
forced alarm, the event buffer shows the (deliberate) zone opening but
shows no attempts to communicate at all. There are no FTCs in the
buffer, and no call is made to my cell phone. Other than this

Hi, I recently removed the power & battery (Yuasa)  from my panel as we
were having work done on our home. After several days when the work was
completed I restored the power. The problem was the date & time were as of
when I removed the power. Don't these boards have battery ...

Well I have a reason to buy a security system now that I almost lost
my new atv.
So whats your opinion on me getting ADT to come out and install, or me
buying the Powermax + system and doing it myself.

So when I arm my FA168CP unit, I get the normal delay beeping.
However, when this is over, the siren sounds for 1-2 seconds.
Otherwise, the system works as I would expect it to...
Is this normal?

Does anyone have any suggestions for a low cost alarm monitoring service
which is licensed in Naples FL (Collier County)?
Thanks,