Homeowner Forum / Security Alarms / October 2003

Just another manual needed to programm an old Eagle Crow 4700 DL. Can
somebody help?
Thanks again in advance!

I do data and phone cabling presently and am getting more alarm install
requests and tired of turning them down.
Thanks

Wireless Alarm Systems (WAS) using a single frequency spectrum band
are unreliable during Radio Frequency Interferences (RFI).
This happens when transmitters located in the vicinity of your
premises transmit on your WAS frequency.

US products pretend to do Spread Spectrum (SS) on the 868MHz band but
nobody specify that the receiver receive INDIVIDUALLY each hopped
frequency.
If a large bandpass is used to tune-in all hopped frequencies, the

I am thinking about buying a Texecom Veritas 8 panel with a RKP for a simple
domestic installation.
What does this group think about my panel selection ?
I have seen one or two postings slagging them off, but my local supplier

This is something my wife brought home from work:
a.  The number of physicians in the US numbers about 700,000
b.  Accidental deaths caused by physicians per year are 120,000
c.  Accidental deaths per physician (according to the US Dept. of Health &

Folks i'm tring to decide between two DVR units, namely the pelco
DX3100 series and Philips DIVAR  series...
Requirements are straight forward
1) Must be able to support remote viewing over the internet (ADSL)

I'm not sure how to trip my wireless touchpad so my Simon-2 will see
it as a sensor.  The touchpad is a iti Hand Held Wireless Touchpad,
model 60-348-10-95.
Thanks your your help.

Does any one have posted the programing sheet for the ADT
2000 OEM by ademco  Same as the Vista 20SE
Thanks
Stephen Wolf

Dear NG readers,
i need the installation manual of Caddx Networx NX8. Can somebody e-mail me?
Thanks in advance!
Spyros Kintzonides

does anyone have a installation manual or wiring diagram for dsc power832
pc5010 board
thank in advance

My house has a FBI Star XL 4600 alarm installed in it.  The system was
here when we bought the house.  We are the 3rd owners, and the people we
bought from had no clue about thet system.  Until recently, the only
problem I've had is when I shut power to the house to do some ...

I currently have a DSC PC1555 Alarm system (supposedly similar to the
power832 alarm) with a DSC LCD-5501Z keypad. I recently bought a DSC
LCD-5500Z keypad and would like to replace the 5501Z. Do I need to
remove the AC power to the control panel and disconnect the

My alarm is giving me some trouble.  My alarm can go for a day or two
without a problem and all of a sudden show a fault.  That fault is so quick,
that by the time I look at the display, the alarm is ready to arm.  I use
mostly Radionics alarm parts.  Any suggestions in how to fix ...

France
Septam
AVIGNON
Pôle d'activités de Fontcouverte - 891,