Homeowner Forum / Repair / April 2008

(paypal accept)(www.all-wholesaler.com)cheap wholesale china Nike
Jordans ,
Jordan 1 jordan 1.5 jordan 2 jordan 3 jordan 3.5 jordan 4 jordan 5
jordan 5.5 jordan 6 jordan 6.5 jordan 7 jordan 8 jordan 9 jordan 9.5

I have been looking for something that probably doesn't exist for
reasons I don't know.
I am trying to find out if there is such a thing as a heat exchanger
for a dryer that would attach like a humidifier to a furnace?

Hi all. I need help understanding some parts of the NEC as they
pertain to my sevice feed and sub panels.
I had my service loop replaced recently from an old 60 amp service
that fed 2 55 amp sub panels directly from a fused disconnect at the

We have lived in this house about 9 years, and have found another
problem. Pulled a patch off wall in one back room that we never used
and found wiring that was stubed out, looked like a fixture may have
been there . checked voltage and it was 39.4 there is no switch

I have always coped inside corners in crown molding.  It's the way I was
taught, and it's the way the books say, and it's the way it's been done in
all the old houses I've worked on.  However, after all these years, I'm still
not sure why it's better to make a coped joint instead ...

On the first day the Devil went to work, she created
Lawyers, HMO's, and electric stoves.  I have an
electric stove - never again.
The lower burner died.  My childbride cleaned the oven

I've been looking to replace my cast iron 10" miter saw before I
seriously get hurt. Among other things the brake is shot, cord strain
relief going into motor housing is half broken (probably from using at
10 below zero), doesn't cut 45 degree bevel 90 degrees perpendicular.

My vent covers keep falling to the ground in my newly finished
basement.  I don't want to use screws to hold them up as it will put a
hole in the vent cover and a hold in the gyprock.   Any other idea on
how to hold them into place without putting holes in the vents ?

Is there a special way that multiple mower blades should be re-
installed after changing? I was talking to a neighbor the other day
about my grass cutting woes and he said that there were instructions
on the 'net but I cant find them. I get a hump in the middle of my cut

Had a Basement Watchdog installed today, along with a brand new Rigid
Sump Pump.
Had a question on the Basement Watchdog......
How long does the initial battery charge take? Or when you add the

Can anyone recommend a good video security system? I need one that can
see at night,must be outdoor compatible,  uses motion sensing and can
record to a DVR. The most important thing for me is image quality, it
must be very good. I always see those grainy crime videos on tv and

Hello all;
Ok whirlpool quiet dishwasher...1.5 yrs old and now it is VERY loud
manufacturer said warranty over and repair is not cost effective?
removed motor, cleaned screens and still loud...I'm fed up with

The cheap laminate on the counters in our trailer is falling off again.
Any advice for what adhesive to use to hold this stuff down?  It is mainly
the edge, not the tops.  Thanks.
Mike D.

Ok, I'm a dummy.   I put 4 ceiling boxes on the same switch, now I want to
control them separately.  What are my choices besides:
 1.. rewiring
 2.. pull chains

I have a 5 yr. old Insinkerator (Badger5) garbage disposal.  It still
turns - but doesn't grind up anything.  Is this about the average age
of a garbage disposal?  I will go shopping for one in the next few
days and would like to know whether to get another one like this or