Homeowner Forum / Repair / February 2008

I had to repair some fencing awhile back due to a big wind storm. I
needed to to replace some screws so I bought some Hillman PowerPro 8x2
Bronze Ceramic coated screws. I put them in last november and now have
to do some final adjustments on the fence. I had to pull the new ...

www .chapforwholesale. com
(www.cheapforwholesale.com)  nfl jersey wholesale womens nba
jersey ,nba
jersey sale ,cheap authentic nba jersey ,07 jersey nba star ,nba

I'm a bachelor.  I have a large quilt or maybe it's not really a
quilt, but a thick warm blanket.  It's been on my bed for several
years and really needs to be washed.  I have a normal home washing
machine, not just one of those small apartment sized ones.  This

Where is a "safe place" to dispose of small, 14 oz. propane tanks?
The web is no help.

About a year ago I replaced a bad motor to transmission coupling on a
Kitchen Aid washer. Today, the washer stopped spinning. I took a look
and the coupling had broken. While I had everything disassembled, I
rotated the tub with my hand and noticed the transmission shaft that

I have a old MW machine that has a 5hp B/S Eng.
   New plug ,carb kit and I still have to prime it through the plug hole to
start it. Can these engines be retrofitted with a primer kit?
         Frank

Hi all:  I have a six-year-old (warranties have long-since expired!) Mitsub.
Diamond series 65" rear projection TV that has recently developed what I
assume is a convergence problem.  Pix is blurred, the three colors are
visible (like looking at a 3D film without the special ...

I just bought an American Standard Cadet 3 toilet. After bolting the
tank down to the bowl and tightening it as much as I feel comfortable
doing, the tank is very wobbly on top of the bowl. The rubber gasket
between the tank and bowl is pretty thick (1 inch) and spongy. The

How would I control my front porch light using my computer? Are there x10
devices with certain software or is there something I can plug into my
computer to do this? I don't want just a timer or a "Clapper" that I plug
into the wall. I want to be able to start a program from my ...

I'm installing sheet vinyl on my basement floor and ran out of
adhesive with about ten sq ft remaining.  I could buy a quart of
adhesive, but I've got some wall tile adhesive left over from a
kitchen remodeling job that will likely be discarded the next time I

My front-load clothes dryer grabbed one of the garment care
tags and hung the garment while is spun the rest of the load of
clothes. I managed to get the entire tag removed without
shredding it but now the tumbler barrel is squeaking on every

My Frigidaire FDB421RF dishwasher is stone dead--no switch position or anything
will make it do any thing.  The wiring diagram shows a door switch as completely
interupting power.  The illustrated parts breakdown does not show where the door
switch is.  It is not obvious from ...

I am going to replace some of my existing recessed lights, and when I took
one off and measured the knock out hole, it is exactly 7" in diameter.  I
thought that means I have a 7" housing but when I visited various web sites
and looked at their 6" lights, most of them have a ...

The old main valve of my house doesn't stop the water flow very
tightly when shut off. I need to install a new main valve. It's on
3/4" copper pipe. I'll install the new valve just over the old one.
The problem is that the old pipe is now more oval in shape than round

My aunt thinks some of her family is coming in her house when she is
gone.
I have suggested she use a camera clock I have seen on the Internet.
Can someone that has used one suggest features to look for?