 |
 | Home | Contact Us | FAQ | Search & Site Map | Link to Us |
 | Sign In | Join | Other 45 Sites in Network |
| HomeDiscussion GroupsGeneralRural LivingHome AutomationSecurity AlarmsConstructionRepairPlumbingCleaningPest ControlLawn and Garden |
Homeowner Forum / Repair / May 2006ABS Cement Drying Time
I just did a repair with ABS cement. There is nowhere on the can that states drying time. It just says, "Allow cement to fully cure before handling assembly." Duh! How long would that be? The part is in the full sun since 9 AM this morning. I just went up there and touched it, and it is still a bit soft. I figure 8 hours at 90 degrees F in the full sun should be adequate to apply water pressure. But, what is the correct answer? I may just leave the pressure off for 24 hours and be extra sure. It's to the solar heater, and I like the water warmer than it is without the heater. Steve > I just did a repair with ABS cement. There is nowhere on the can that > states drying time. It just says, "Allow cement to fully cure before [quoted text clipped - 12 lines] > > Steve What are you using the cement to repair. The reason the cure time is not listed is that it varies greatly on many factors including how much water you mixed it with, tempature, humidity, etc. > I just did a repair with ABS cement. There is nowhere on the can that > states drying time. It just says, "Allow cement to fully cure before [quoted text clipped - 12 lines] > > Steve Scratch that, wrong cement!! >> I just did a repair with ABS cement. There is nowhere on the can that >> states drying time. It just says, "Allow cement to fully cure before [quoted text clipped - 14 lines] > >Scratch that, wrong cement!! Link for choices: http://www.ppfahome.org/cements/faqcements.html Oren "My doctor says I have a malformed public-duty gland and a natural deficiency in moral fiber, and that I am therefore excused from saving Universes." According to Steve B <boozoochavez@zydeco.net>: > But, what is the correct answer? I may just leave the pressure off for 24 > hours and be extra sure. It's to the solar heater, and I like the water > warmer than it is without the heater. The instructions I've seen always say 24 hours before applying any pressure.  SignatureChris Lewis, Una confibula non set est It's not just anyone who gets a Starship Cruiser class named after them. I left the ABS cement on for 24 hours. I had wrapped the leaking point with strips of plastic woven fabric, laying down glue, a glued strip, and then lots of glue on top to seal. So far so good. The leak was in an awkward place in a solar heating collector system. I believe that by waiting 24 hours, it was as good as it was going to get. 95 degrees F. in the direct sun helped a bit, too. After 30 minutes, I went up there every thirty minutes and pressed on the fabric to make sure it made a tight fit as it dried. We'll see how it holds as the summer goes on. Steve |
Reply to this Message |
 Sign In
 Join
 My Latest Posts My Monitored Threads My Blog My Photo Gallery My Profile My Homepage Start New Thread Enable EMail Alerts Rate this Thread
|
©2010 Advenet LLC Privacy Policy - Terms of Use
This website includes both content owned or controlled by Advenet as well as content owned or controlled by third parties.