OMNI Pro II Zone Secure Issue

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

DeputyDawg - 30 Oct 2005 04:48 GMT

Hooked up 3 windows to the same Zone. To get an NOT READY ALL 3 Windows
have to be breached. How can I make it so that if only ONE is breached it
would show NOT READY? I wired all 3 together and then onto the single wire
running to the OMNI Pro II board.

Reply to this Message

jmj1492@msn.com - 30 Oct 2005 06:23 GMT

You'll need to wire them in series, no parallel.

Reply to this Message

DeputyDawg - 31 Oct 2005 00:18 GMT

Thanks. It did the trick.

::: You'll need to wire them in series, no parallel.

Reply to this Message

Flavio Silva - 30 Oct 2005 07:05 GMT

Test
Hooked up 3 windows to the same Zone. To get an NOT READY ALL 3 Windows
have to be breached. How can I make it so that if only ONE is breached it
would show NOT READY? I wired all 3 together and then onto the single wire
running to the OMNI Pro II board.

Reply to this Message

Homeowner Forum / Home Automation / October 2005

OMNI Pro II Zone Secure Issue